Dynamic dns not updating
If the IP address does not match the one listed by your hostname, you will need to manually update it to get your service working again.
How do I manually update my hostname in my No-IP account?
Note: You should only open the ports that are needed to gain access to your applications.
If the update client gets turned off, or if the computer is shut down or falls asleep, the update client will stop working and we will not receive any updates. If your hostname is showing the correct IP address, but you cannot connect to your device, the next step is to make sure that the hostname is resolving properly.To manually update the hostname, login to your No-IP account and click Hosts/Redirects at the top left of the page.Next to the hostname that you need to update click “Modify”.On the next page, under the Hostname Information window, you will see a location to change the IP address.Replace the IP address being shown with the IP address you received from Port Check Tool and click Update Host at the bottom right of the page.
This document will tell you how to setup a dynamic DNS host name under the D-Link DDNS service with your D-Link router. After entering your user information, you will be sent an e-mail to verify your e-mail address and confirm your account. This account, with the username and password you enter, is also good at Click the add host link, fill in a host, and then click add to create the hostname.